13-1020

Copper Corrosion Testing Apparatus, 1-place

ASTM D 849

Consisting of:
1 constant temperature bath with special bath lid
1 flask, 250 ml capacity
1 condenser, 250 mm
1 stopper with hole and slot for flask
2 copper strips, pack of 10
1 m of copper wire
1 polishing vice, 1-place

Power supply: 230 V, 50/60 Hz

13-1028

Copper Corrosion Testing Apparatus, 4-place

ASTM D 849

Consisting of:
thermostatic bath made of stainless steel (20 l volume, heating power 2000 W, electronic temperature control up to 150 °C, temperature constancy ±0.02 °C, digital display, over temperature and low level protection)

Supplied with:
4 glass flasks, 250 ml capacity with taper joint
4 Allihn condensers
4 flask suspension stoppers
8 packs of 10 copper strips
4 packs of copper wire, each 1 m in length
1 polishing vice, 1-place.

Power supply: 230 V, 50/60 Hz

13-0708

Set of Copper Strip Corrosion Standard

ASTM D 130

13-0727

Silicon Carbide Grit Paper, 100 grit (P100), 10 sheets

13-0719

Silicon Carbide Grit Paper, 150 grit (P150), 10 sheets

13-0720

Silicon Carbide Grit Paper, 240 grit (P280), 10 sheets

13-0721

Silicon Carbide Grit Paper, 360 grit (P600), 10 sheets

13-0722

Silicon Carbide Grit Paper, 500 grit (P1000), 10 sheets

13-0723

Silicon Carbide Grit Paper, 600 grit (P1200), 10 sheets

13-0730

Polishing Vice, 4-place

holding up to 4 metal test specimens
(Note: without metal strips)

11-0022

Thermometer

Range: 0 to +105 : 0.5 °C

13-1022

Flask, 250 ml, with standard taper ANS 29

13-1023

Stopper, NBR-rubber (50/40 / bored)

with center hole and slot for flask attachment

13-1025

Copper Wire, Ø 1.6 mm x 1 m

13-0172

Allihn Condenser, 250 mm, NS 29/32

14-0056

Metal Test Specimens

for Copper Corrosion Test of LPG
ASTM D 1838

Material/Composition: Copper
Dimension: 12 x 2 x 75 mm with hole 3.2 mm
Pack/Set: 10

13-0711

Polishing Vice, 1-place

holding 1 metal test specimen
(Note: without metal strip)

Minimum equipment:

1x Copper Corrosion Testing Apparatus, 13-0708

Spares (approx. 1 year):

14-0056, 13-1022, 13-1023

Additional requirements: