10-0700

BBR - Automatic Bending Beam Rheometer

ASTM D 6648 - AASHTO T313
Superpave®: SHRP 1002, SHRP B-002

Consisting of:
- Tempering Bath: with heating module and compressor cooling
- Test Frame: motor displaceable between charging and measuring position
- Control Electronics: consisting of servo amplifier with load control and
   amplifier for the measured force signal.
- Software: for the measuring process, as well as for the display, evaluation and
   storage of the measured data on a PC.

Note: molds, circulator cooling bath (for sample preparation), PC and Printer are not included.

Power supply: 230 V, 50 Hz

10-0701

BBR - Automatic Bending Beam Rheometer

Like 10-0700 but:
Power supply: 115 V, 60 Hz

10-0702

BBR - Automatic Bending Beam Rheometer

Like 10-0700 but:
acc. to EN 14 771

Power supply: 230 V, 50 Hz

10-0706

Beam Molds (acc. AASHTO, ASTM, EN), pack of 5

25-0242

Circulator (external & internal heating & cooling)

For heating & cooling of instruments without circulation pump
and / or for tempering applications directly in the bath.

Consisting of:
Cooler with stainless steel bath. Thermostat with digital display, splash-proof keypad, integrated heater, pump, RS232-interface, over/under-temperature & low-level protection, adjustable pump-pressure, cooling control.

Supplied with:
1 bath cover, 1 drain tap, 1 insulated hose-set (Ø 8 mm, 2x 2 m)

Note: Insulated hose-set is recommended

Technical Data:
Working range: -35 to +200 °C (at +5 to +40 °C ambient temp.)
Display / Resolution: LED / 0.1 °C
Control: PID
Heater capacity: 2000 W
Cooling capacity: 450 W at +20 °C
Pump-Pressure capacity: 11-16 l/min, 450 mbar
Bath opening: 18 x 12 x 15 cm (WxDxH)
Safety class / Bath fluid: 3 / FL (Flammable Liquids possible)
Volume: 8 l
Sockets for: hose (Ø 8 / 10 mm)
Dimensions / Weight: 31 x 42 x 64 cm (WxDxH), 37 kg
Power supply: 230 V, 50 Hz, EU-plug

25-0243

Circulator (external & internal heating & cooling)

Like 25-0242 but:
Heater capacity: 1000 W
Power supply: 115 V, 60 Hz, US-plug

10-0707

Force Calibration Kit

10-0708

Temperature Calibration Kit

Consisting of:
- Precision Digital Thermometer and
- Probe with cable and DKD-calibration certificate
  for two different test temperature points

Minimum equipment:

1x 10-0700 + 10-0706

Spares (approx. 1 year):

Additional requirements: